Spring Gears
Posted: Sat Jun 14, 2014 12:07 pm
I just ran across a link to a picture of a spring gear (Daid is the 3D slicer Cura's main developer).
Does this have any potential for reduced backlash 3D printed gears? It might work as another spoke type, so no major development effort.
Something for the next development season's to-do list?
Kirk
Does this have any potential for reduced backlash 3D printed gears? It might work as another spoke type, so no major development effort.
Something for the next development season's to-do list?
Kirk