GearHeads Corner

Art,

I have tried over and over to convert the file that is attached here
into 2 separate spoke files in Gearotic.

One file for each direction, so I can make wheels with this spoke that
I have designed.

I cannot seem to get it to work.

Is it asking too much of you to create two separate dxf files for me?

If so, I understand, you have better things to do....

Thanks,

Richard

I think its due to them bending too far out.. If that happens, add a tab like I did here , it allows you to see why they fail..

Art

Art,

Works great................thank you so much....

Richard