Finished a 3d print of a timing pulley

A discussion and development of a 3d printer is located here.
Post Reply
GlennD
Old Timer
Posts: 80
Joined: Tue Oct 18, 2011 4:19 pm

Finished a 3d print of a timing pulley

Post by GlennD »

Used GM to get the profile of a 8 tooth T5 timming pulley brought a DXF into Inventor and made the pulley to fit my
RepRap was pretty easy to do.
So Thank you Art, Bob and group for your efforts.

Glenn
Image
Last edited by GlennD on Thu Apr 05, 2012 7:02 am, edited 1 time in total.
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest