Re: Lasers - general chat.
Posted: Fri Aug 14, 2015 1:10 pm
Kirk:
I used blue. I dont find its picky at all, but I think my 50watt is too low a power to care. I go about 6mm/sec
at 100% to cut 1/4" plywood cleanly. Make sure you add air assist, it really helps, I use my shop compressor
at around 5psi or so..
Art
I used blue. I dont find its picky at all, but I think my 50watt is too low a power to care. I go about 6mm/sec
at 100% to cut 1/4" plywood cleanly. Make sure you add air assist, it really helps, I use my shop compressor
at around 5psi or so..
Art