Page 1 of 1
Genevas
Posted: Sun Mar 31, 2013 11:37 am
by Eastblock
The first one is generated in Gearotic Motion.
http://www.youtube.com/watch?v=_uuhceWZXkg
Re: Genevas
Posted: Sun Mar 31, 2013 12:55 pm
by BobL
Eastblock;
Good job I like it..
Cheers
Bob
Re: Genevas
Posted: Mon Apr 01, 2013 12:52 am
by ArtF
Love it.. For some reason the fluid flow of those geneva's makes me happy. :)
Art
Re: Genevas
Posted: Mon Apr 01, 2013 5:35 pm
by Eastblock
The one generated with GM does need a fair bit of push to get the cage wheel to move. Making the sprocket from acetal might make it a little bit smoother.
Re: Genevas
Posted: Mon Apr 01, 2013 6:01 pm
by ArtF
Hi:
Yes, Im pretty sure thats the accute pallet angle it has. I did that to eliminate as much slop as I could at mesh point (Inverted geneva's are known to be a bit sloppy..), but I think its too severe. I do have it on my development list to try to reduce that angle to make it easier to engage the tooth...
Thx
Art
Re: Genevas
Posted: Tue Apr 02, 2013 1:44 pm
by Nic Bwts
nice work! Laser cut?
Re: Genevas
Posted: Wed Apr 03, 2013 3:52 am
by Eastblock
Yes, I have a couple of Chinese CO2 lasers that I use in my business.