GearHeads Corner

Posted: **Fri Feb 03, 2017 9:30 am**

Thank you....

Each piece is separate, I did not want to mount any type
of backer board.  I used 3M super bonding double sided tape
for each segment.  Not easy to do, but worth the effort.

I think if I wanted to take it down, I would have to install new
drywall and paint!

I am not sure what you mean by inlays?

R

Posted: **Fri Feb 03, 2017 10:48 am**

See  https://www.youtube.com/watch?v=Yq4akQnHWSE  obviously I am not starting out with such a complex piece.
Dan Mauch

Posted: **Sat Feb 04, 2017 7:56 am**

Dan:

How do you figure their getting that 3d enhancement?

Art

Posted: **Sun Feb 05, 2017 6:36 am**

I'm not sure how they did it but I think it is how bright one object is over another.
Dan

Posted: **Sun Feb 05, 2017 8:15 am**

They speak of engraving deeper on some areas then filling with clear resin.. interesting result..quite 3d'ish

Art

GearHeads Corner

laser cut clock face and backing

Re: laser cut clock face and backing

Re: laser cut clock face and backing

Re: laser cut clock face and backing

Re: laser cut clock face and backing

Re: laser cut clock face and backing