GearHeads Corner

Hi
With the previous version we were able to turn the esc-pallet at any position. Somebody know how we can do the same with the new version 2.0
Regards

Rene;

Have you tried holding down the center mouse button and sliding the mouse to rotate it?  I don't think it matters to how you position it in your view plane, simply add gears from there and it should work, I think...


Cheers
Bob
:)

Rene:

  Its not possible as yet in GT to move the escapements to other than default position. It is on my development list but not yet available..

Art

Thanks for yours comments

Hi Rene:

  As of next version the first two lever escapments can be placed at any angle again..

Thx
Art