GearHeads Corner

I designed a Wood clock 64 Tooth wheel and an 8 tooth pinion and then saved them.
Later I opened the file and revised the design.
when I tried to save the file again the system would not respond.
How do I revise and save old files?
Dan

Dan:

  Once the system knows beyond a doubt the project name and file locations, it will seem to not respond, but it IS svaing over the project.
You make a good point though, Ill add a system message that the project has been saved for next release. Good timing, Im fixing up last minute
bugs for an imminent release.

Thx
Art