In Gearotic2 the boxing only create the square, dont create the holes of the shafts, in the dxf file fails too, no holes.
P.D.: Fails when selected only "front". When selected "rear" too, then works fine.
Boxing (Plateing)
-
- Old Timer
- Posts: 12
- Joined: Fri Mar 04, 2011 10:18 pm
Boxing (Plateing)
Last edited by Salvador Ruano on Fri Mar 02, 2018 10:07 am, edited 1 time in total.
Re: Boxing (Plateing)
Salvador:
Thx for the notification, Ill check out why,
Thx
Art
Thx for the notification, Ill check out why,
Thx
Art
Who is online
Users browsing this forum: No registered users and 69 guests