Spindle Question
Posted: Thu Aug 08, 2019 7:45 am
Hi Art
This isn?t a Gearotic question but maybe you could offer an option/advise.
I just purchased a Koolertron brushless 500 watt spindle (I am not an electronics guy and doubt that I could fix the one they sent me). The motor is great but the motor controller has some sort of problem and turns the motor but only slowly.
The voltage out put is only about 15 volts and the motor is rated at 48 volts. I shopped around and found a Knacro power supply that matches the motor specs I could find.
Question Am I likely to fry everything in site if I hook these up?
This isn?t a Gearotic question but maybe you could offer an option/advise.
I just purchased a Koolertron brushless 500 watt spindle (I am not an electronics guy and doubt that I could fix the one they sent me). The motor is great but the motor controller has some sort of problem and turns the motor but only slowly.
The voltage out put is only about 15 volts and the motor is rated at 48 volts. I shopped around and found a Knacro power supply that matches the motor specs I could find.
Question Am I likely to fry everything in site if I hook these up?