Page 1 of 1
Gear information question.
Posted: Fri Oct 04, 2013 2:30 am
by Ken_Shea
The helical wheel and/or pinion gear information shows Left-Hand when the Left hand box is not checked and shows Right-Hand when it is, normal ?
Again, likely thinking about wrong.
Ken
Re: Gear information question.
Posted: Fri Oct 04, 2013 3:20 am
by ArtF
Ken:
No, thats likely me.. :) I'll check it and fix it up..
Art
Re: Gear information question.
Posted: Sun Oct 06, 2013 12:29 pm
by Ken_Shea
I've created a gear in GT and saved it.
When it's loaded back in GT the screen gear information does not show the DP or Helix angle and I can't seem to get that information from any screen that is tried.
Thanks
Ken
Re: Gear information question.
Posted: Sun Oct 06, 2013 2:04 pm
by ArtF
Ken:
Quite right. I do see he helical angle, ( 2nd line down on the data lines ), but I did neglect to add the DP or module. I will
correct that for the next release later this month.
Thx
Art
Re: Gear information question.
Posted: Sun Oct 06, 2013 3:01 pm
by Ken_Shea
Ha Ha, that's amazing how that was over looked and it was looked through numerous times.
Thanks
Re: Gear information question.
Posted: Sun Oct 06, 2013 3:18 pm
by ArtF
Ken:
I know... its the little things that get you..
Art