Page 1 of 1
version 2.30007c
Posted: Sun Jan 03, 2016 4:07 am
by ArtF
Hi all:
New version, only changes are in Auggie,
Proper Syntax highlighting, libraries, and bug fixes
to some arc motion errors..
Thx
Art
Re: version 2.30007c
Posted: Sun Jan 03, 2016 8:51 am
by BobL
Thanks Art...
Re: version 2.30007c
Posted: Wed Jan 06, 2016 10:49 am
by Mooselake
Just for grins (working with the 3D printer today) I generated a bottom plate stl for a couple eccentric gears and imported it into slic3r. There weren't any shaft holes - I was expecting there to be 2 8mm holes. I also checked it with the Repetier-Host viewer.
Slic3r also complained about 4 degenerate facets, but I didn't try netfabb to see what or where they were.
No big deal, I should be installing the new table in the laser anyway.
Kirk
Re: version 2.30007c
Posted: Wed Jan 06, 2016 11:01 am
by ArtF
Kirk:
Hmm, did the plate have holes in Gearotic?
Art