bevel gear placement

[Gavin]

Hello,
not sure if this a bug report, a feature request or a support question.
when I create bevel gears at 90deg It would be very helpfull to know where to place the shafts.

I see a "gear center" figure but this only applies if the bevel was laid at 0deg.

Gavin.

[ArtF]

Gavin:

  Very true, and on my list for future dev. Since the hole would be elongated
it wasnt initially supplied when I did that section of the engine.

Thx
Art

[Gavin]

I think I get the correct information from shaft posit origin from the project screen so no problem.